SoftRF LoRa module
This module is designed to be pin-to-pin compatible with Nordic NRF905-based one.
Physical dimensions are very close.
- better link budget ;
- very flexible RF chip settings allow implementation for variety of radio protocols, such as (FSK modulated):
- when Semtech's proprietary LoRa modulation is in use, operating range of the SoftRF is increasing up to 2-4 times under same Tx power level.
One known good implementation of the LoRa modulation for aviation proximity awareness is:- FANET protocol (Skytraxx)
If you would like to print the schematics I would suggest to use this PDF file.
You can order the PCB direct from manufacturer: 1
It should typically cost you around 3 USD for minimum 4 pcs of PCB with basic international shipping included in.
Expect to wait:
- 1 week for panelization
- 2 weeks for fabrication
- 1-2 weeks for delivery to your location
Alternatively you may pick these Gerber files and order the PCB from a local manufacturer of your preference.
1 - SSL Cert error warning may come up - it is known to be safely ignored
| Number | Part | Qty | Picture | Source |
|---|---|---|---|---|
| 1 | PCB | 1 |  |
|
| 2 | HopeRF RFM95-868 | 1 |  |
AliExpress |
| 3 | Female SMA-KHD | 1 |  |
AliExpress |
| 4 | 2x7 male header 2.54mm | 1 |  |
Local |
| 5 | Capacitor 10uF | 1 |  |
Local |
| 6 | 1x40 male header 2.54mm | 1 |  |
AliExpress |
No known errors.
This module revision has no connection between RFM95W's RESET pad and MCU.
Although there were no any issues detected in operation with current SoftRF firmware, in theory this may
cause unwanted behaviour when SoftRF user switches RF protocol from any FSK-based (Legacy, PAW, OGN) onto LoRa-based (FANET) or backward.
Full "power off" - "power on" cycle of the unit should help as a workaround.
Solder a wire as shown on this picture:
