Dongle Edition. Quick start

1. Download firmware binaries into your Dongle Edition. Follow these instructions. ¹

   ¹ - this operation is typically not required when the T-Motion board comes with factory pre-installed SoftRF firmware.
   

2. Install LK8000 application onto your Android tablet from Google Play

3. Execute the application, then select "FLY" mode

4. Plug the Dongle into the tablet's USB slot. Confirm connection of the app to the USB device in pop-up window, if necessary.

5. Touch "Menu" screen area:

6. Select Config -> Config 2/3 -> LK8000 Setup -> Device Setup ,
   then choose connection settings as follows:

7. Touch Terminal button. You should see a flow of NMEA messages, similar to shown on this picture:

8. Return back to LK8000 main screen.
   

9. Move your tablet (with the Dongle) into an area of good GPS/GLONASS reception and wait until it will pick satellites up. The app will show your current location on the map:

10. Tap few times right to reach Radar View. When any other traffic ^{(OGN Tracker or another SoftRF unit)} is around - you should see it on this screen: