-
Notifications
You must be signed in to change notification settings - Fork 200
Software ~ Advanced ~ Ethernet Hotspot
- Set
ETHERNET_HOTSPOT=Yin wifibroadcast-1.txt to enable the Ethernet hotspot - Connect a RJ-45 cable directly from your PC to the Pi Ethernet port (don't use any hub or switch), if you also have a HDMI monitor connected, you should see a message that the device has been detected.
- The IP of the Pi is now 192.168.1.1, and your PC has recieved 192.168.1.2.
- When the Ethernet hotspot is on, the wifi hotspot doesn't work.
General
Hardware Setup
- Proper Wiring
- Power Supply (BECs)
- Supported Pi models
- Supported Cameras
- Supported WiFi Adapters
- Supported Displays
- Antennas
- DIY builds
Software Setup
- Basic configuration options
- Advanced Options
RC Control
- General
- RC with Ardupilot (MAVlink)
- RC with iNav
- DIY builds
Ground Stations
- Mission Planner (Windows)
- QGroundControl (Windows / Linux / Mac / Android /iOS)
- APM Planner (Windows / Mac / Linux)
- Tower (Android)
- FPV_VR (Android)
- GStreamer (Windows / Mac / Linux)
- Fishing FanCam (iOS)
Expert Settings
- OSD MAVLink message types
- Transmit power settings
- SSH shell
- Raspivid camera settings
- Optimizing-Power-Consumption
Extensions / AddOns
- HDMI-in cards
- WebCams
- Video Switcher
- Thermal (FLIR, Seek)
- 360° cameras
Community-HUB
Developer's Corner
- Room for Improvement
- Mounting Images
- Reducing Images size
- WinSCP (copying files)