Onshape

Organization Convention:

   Folder for imports outside of the file, File for each

Naming Convention:

"Name of Part - Part Group Name" for each part, NOT just Part 1, Part 2, etc.

• Example: Lid - Motor Backpack, Case - Motor Backpack
• Use the Properties tab for the description
• Material / Manufacturing Method
• Design Notes "Name of Part Group - PS" for Part Studios "Name of Rover Subsection - AS" for Assemblies

Imports:

     Put the import into the Imports Folder and name it descriptively.
     "Name of PCB, Rev Letter, Date Imported"
     Use the description tab under properties of the part studio or assembly to describe the purpose if it has a similar name to another part.

Variables:

Make the names descriptive or use the description tab if it is too long of a name.

Measurement Convention:

Metric, ideally things are in 5mm increments or even numbers unless there is a specific reason

Manufacturing/Assembly Conventions:

The smaller parts that are commonly tested should have easily accessible screws for quick removal, while more permanent fixtures can have slightly harder-to-reach screws. Check in the full assembly that parts can be reached