doc: release: 4.0: Add Espressif changes.

Adds notes on Espressif changes to this release.

Signed-off-by: Sylvio Alves <[email protected]>

doc/releases/release-notes-4.0.rst

@@ -158,10 +158,13 @@ Boards & SoC Support
 
 * Added support for these SoC series:
 
+  * Added ESP32-C2 and ESP8684 SoC support.
+
 * Made these changes in other SoC series:
 
   * NXP S32Z270: Added support for the new silicon cut version 2.0. Note that the previous
     versions (1.0 and 1.1) are no longer supported.
+  * Added ESP32 WROVER-E-N16R4 variant.
 
 * Added support for these boards:
 
@@ -209,6 +212,7 @@ Boards & SoC Support
    * :ref:`Renesas RA6E2 Fast Prototyping Board <fpb_ra6e2>` (``fpb_ra6e2``)
    * :ref:`Renesas RA8T1 Evaluation Kit <mcb_ra8t1>` (``mck_ra8t1``)
    * :zephyr:board:`Renode Cortex-R8 Virtual <cortex_r8_virtual>` (``cortex_r8_virtual``)
+   * :zephyr:board:`Seeed XIAO ESP32-S3 Sense Variant <xiao_esp32s3>`: ``xiao_esp32s3``.
    * :ref:`sensry.io Ganymed Break-Out-Board (BOB) <ganymed_bob>` (``ganymed_bob``)
    * :zephyr:board:`SiLabs SiM3U1xx 32-bit MCU USB Development Kit <sim3u1xx_dk>` (``sim3u1xx_dk``)
    * :ref:`SparkFun Thing Plus Matter <sparkfun_thing_plus_mgm240p>` (``sparkfun_thing_plus_matter_mgm240p``)
@@ -294,6 +298,9 @@ Drivers and Sensors
 
 * ADC
 
+  * Added proper ADC2 calibration entries in ESP32.
+  * Fixed calibration scheme in ESP32-S3.
+
 * Battery
 
 * CAN
@@ -326,6 +333,7 @@ Drivers and Sensors
 
   * Fixed SPI NOR driver issue where wp, hold and reset pins were incorrectly initialized from
     device tee when SFDP at run-time has been enabled (:github:`80383`)
+  * Updated all Espressif's SoC driver initialization to allow new chipsets and octal flash support.
 
 * GNSS
 
@@ -340,10 +348,18 @@ Drivers and Sensors
 
 * I2S
 
+  * Added ESP32-S3 and ESP32-C3 driver support.
+
 * I3C
 
 * Input
 
+  * Fixed broken ESP32 input touch sensor driver.
+
+* Interrupt
+
+  * Updated ESP32 family interrupt allocator with proper IRQ flags and priorities.
+
 * LED
 
   * lp5562: added ``enable-gpios`` property to describe the EN/VCC GPIO of the lp5562.
@@ -362,6 +378,8 @@ Drivers and Sensors
 
 * Mailbox
 
+  * Added driver support for ESP32 and ESP32-S3 SoCs.
+
 * MDIO
 
 * MFD
@@ -391,6 +409,8 @@ Drivers and Sensors
 
 * SDHC
 
+  * Added ESP32-S3 driver support.
+
 * Sensors
 
   * The existing driver for the Microchip MCP9808 temperature sensor transformed and renamed
@@ -430,6 +450,10 @@ Drivers and Sensors
 
 * Wi-Fi
 
+  * Added ESP32-C2 Wi-Fi support.
+  * Added ESP32 driver APSTA support.
+  * Updated ESP32 Wi-Fi driver to reflect actual negotiated PHY mode.
+
 Networking
 **********
 
@@ -547,6 +571,8 @@ Libraries / Subsystems
 
 * Power management
 
+  * Added initial ESP32-C6 power management interface to allow light and deep-sleep features.
+
 * Crypto
 
   * Mbed TLS was updated to version 3.6.2 (from 3.6.0). The release notes can be found at:
@@ -633,6 +659,9 @@ HALs
 
 * Espressif
 
+  * Synced HAL to version v5.1.4 to update SoCs low level files, RF libraries and
+    overall driver support.
+
 MCUboot
 *******