Linux kernel 5.15 and newer should support the dongle with updated firmware. PipeWire 0.3.38 or newer should have the required audio profiles. PulseAudio 16.0 or newer should have the required audio profiles.
If you are not running older software than what is written above then you should not use this profile.
Product page: https://en-us.sennheiser.com/gaming-headset-wireless-gsp-670
Like some other headphones, the Sennheiser GSP 670 provides a main and a communication audio device.
This custom profile is needed to make PulseAudio detect both the main and the communication devices.
- GSA 70 wireless dongle
- GSP 670 gaming headset
Download the latest *.deb release and install it with dpkg:
sudo dpkg -i pulseaudio-sennheiser-gsp670_x_all.debDownload the latest *.pkg.tar.xz release and install it with pacman:
sudo pacman -U sennheiser-gsp670-pulseaudio-profile-x-1-any.pkg.tar.xzInstalling with pacman will fail if the install script was use before. This is normal and expected since the files already exist on the system.
There are two ways to address this issue:
- Remove the conflicting files
- Tell
pacmanto overwrite the conflicting files
This only has to be done a single time. Once the files were installed using pacman, no errors with conflicting files will occur.
Use the following command to make pacman overwrite the conflicting files:
sudo pacman -U sennheiser-gsp670-pulseaudio-profile-1.1.r3.g627a636-1-any.pkg.tar.xz --overwrite /etc/udev/rules.d/91-pulseaudio-sennheiser-gsp670.rules,/usr/share/pulseaudio/alsa-mixer/paths/sennheiser-gsp670-input-comm.conf,/usr/share/pulseaudio/alsa-mixer/paths/sennheiser-gsp670-output-comm.conf,/usr/share/pulseaudio/alsa-mixer/paths/sennheiser-gsp670-output-main.conf,/usr/share/pulseaudio/alsa-mixer/profile-sets/sennheiser-gsp670-usb-audio.confClone this repository and use the install script:
sudo ./installpulseaudio -k
pulseaudio --startIf the dongle is already connected then unplug it and plug it back in again.