Electronics and Programming Enrichment

Sources

• Javascript Codeacademy
• Arduino comic
• Arduino booklet
• Adafruit's learning resources

Software Required

• Arduino
• Fritzing

Hardware Required

For each student in the class (plus a few extra for buffer):

• Arduino Uno
• USB-B cable
• Mini-breadboard
• 10 2-5" jumper wires (a range of lengths is good)
• 3 alligator clip wires
• 1 potentiometer
• 2 breadboard compatible push buttons
• 3 green LEDs
• 3 red LEDs
• 1 RGB LED
• 1 photocell
• 9 220 ohm resistors (1 for each LED)
• 2 10k ohm resistor (for the force sensor and photocell)
• 1 small DC Motor
• 1 transistor
• 1 diode
• 1 2" x 2" square of conductive foam)

As a shared class resource:

• 20 shift registers
• Bulk resistor pack
• Bulk wire
• Wire strippers
• 10 Micro-servos

As of April 2013, the total total cost for each student is around $50. Ideally, each student is able to take home their Arduino and all of the components they learned about.

Contributors

• Chris Peplin
• Emily Van Ark

Licenses

This code in this repository is licensed under the BSD license and is Copyright 2013, Christopher Peplin.

All other content and documentation is made available under the Creative Commons Attribution 3.0 License, Copyright 2013, Christopher Peplin and Emily Van Ark.