This is a 3D printable car headunit designed to house a Mini-ITX motherboard and 7" touchscreen.
This design has been built using the following components:
| Component | Approximate Cost/€ |
|---|---|
| Gigabyte J1900N-D3V | 88.00 |
| 8GB RAM | 58.00 |
| SSD | 51.00 |
| M3-ATX PicoPSU | 55.00 |
| Molex → P4 cable | 4.00 |
| Touchscreen | 125.00 |
| Left-hand Right angle mini hdmi | 7.00 |
| HDMI cable | 5.00 |
| Right angle DVI | 6.00 |
| M3 Hex bolts | 0.10 |
| M3 Nylock nuts | 0.10 |
| M3 Washers | 0.10 |
| 12v PSU | 10.00 |
Note that for other Mini-ITX motherboards you may want to check the clearance of the SSD mount on the left. On the Gigabyte motherboard the PCI header just fits underneath.
The 3D model is designed in OpenSCAD.
sudo apt-get install openscad inkscape pstoedit
# Create case/openivi-vents.dxf from case/openivi-vents.svg
make
openscad case/headunit.scad