-
Notifications
You must be signed in to change notification settings - Fork 67
Howl FAQ
Press alt_x to open the command line and type set theme= to see the list of available themes. Select one and press enter.
This theme setting directly corresponds to the variable howl.config.theme, which can be accessed programmatically in your init file. The same applies for every other setting available via the set command.
The init config file is located in ~/.howl/ and called either init.moon or init.lua, depending on which language you prefer. The init file is loaded and executed every time Howl is started.
Option 1: Run the save-config command. This saves all current global settings into ~/.howl/system/config.lua. Note that this is not your init file and not meant to be edited by hand. The config.lua file is automatically loaded on restarts and is overridden by any settings in your init file.
Option 2: Add code like the following to your init file:
howl.config.theme = 'Monokai'The above example uses the Howl API to set the theme configuration.
To see a list of all variables, press alt_x to open the command line and type set (with trailing space). This shows a completion list of all variables with descriptions (screenshot).
Yes, starting with 0.6 you can use custom fonts by putting them in a fonts directory within your Howl configuration directory (typically this would be ~/.howl/fonts).
Add code like the following to your init.lua file:
howl.bindings.push({'editor' : {'ctrl_e': 'howl-moon-eval'}})Here the ctrl_e specifies the keystroke of pressing Ctrl and e together and binds it to the howl-moon-eval command.
If you use a init.moon file, a similar example in moonscript looks like this:
howl.bindings.push { ctrl_q: 'quit'
f1: -> howl.command.run howl.interact.select_command!
}- The first line binds
Ctrlandqto quit the editor. - The second line opens the command line and enables the command search immediately and binds that to the key
F1.
Additional key bindings can be added to the table between the brackets { }.
Run the describe-key command. This opens a special buffer which shows the keystroke name for any key you press. Press escape to exit this mode.
Yes. Run the command vi-on. To make this setting permanent, you can add one of the following stanzas to the init file you're using:
Lua (init.lua):
howl.signal.connect('app-ready', function() howl.command.vi_on() end)Moonscript (init.moon):
howl.signal.connect 'app-ready', ->
howl.command.vi_on!This function resembles the behavior of Ctrl-Shift-P in Atom or Sublime Text to open the command pallette and makes it easy to explore the available commands.
As the keystrokes are shown next to the command it is also helpful to memorize the keystrokes.
In your init.moon add this code:
-- open command select list together with the command line when F1 is pressed
howl.bindings.push f1: -> howl.command.run howl.interact.select_command!
When you press F1 the command select will open. You can replace f1 with any other key if you like.
This code gives the same result as pressing Alt-x and then TAB.
The indentation is specified by the indent configuration variable. To set it to any value, say 4, run set indent=4.
Yes. Use the configuration variable completion_skip_auto_within which is a comma separated list of styles. To disable completion within comments use set completion_skip_auto_within@global=comment.
Hooks are defined using the howl.signal module. Here is an example that prints a message every time a file is saved:
howl.signal.connect('buffer-saved', function(buffer) {print('saved a buffer')})
The list of all available signals can be seen by running the describe-signal command.