Configuration script to help setup some useful options on a new Raspberry Pi, especially with the easybotics air-quality station. The script customizes a Raspbian image by making the follow changes:
- google chrome config with default bookmarks
- sets the desktop wallpaper
- installs node-red nodes required by the easybotics air-quality station
Script is a work in progress.
This script accepts 5 flags
-v Enable extra verbosity
-c install easybotics configs for chrome, set the wallpaper, and add desktop icons
-n install node-red nodes, and libraries to support them such as bme280 and neopixel nodes
-m install easybotics led-matrix nodes, and setup node-red to run as root on startup by default
-p reenable the user friendly 'first boot' service
-r enable boot time resizing of the sd image
-b replace piwiz binary with a cutdown one
-i enable camera, I2c, and serial UART
Use 8GB SD Card - makes the DD and Pishrink process faster
Made for use with this base image: https://www.google.com/url?q=https://downloads.raspberrypi.org/raspbian/images/raspbian-2018-06-29/&sa=D&source=hangouts&ust=1542944842860000&usg=AFQjCNGR9aADpKWaoRwloDp-G8cnk1xt_w
First navigate to the folder where you downloaded this repo then:
./imageBuild.sh -vcnm
The exact paramaters to build the image being used by T3 is
./imageBuild.sh -vcnprbi
which is enabling everything except the led matrix specific config
Make sure to watch the script because there are a few prompts you have to say 'yes' too, but make sure to say 'no' to all reboot prompts, some installers try and get you to reboot before the imageBuild is done
script works better if not run as root!
After the script is finalized, shutdown the pi and grab the image; if you do restart then don't close the 'first boot' help service because it deletes itself after running once; this process also expands the image if it was shrunk.
try these commands (in order)
sudo apt-get install git -y
git clone https://github.com/easybotics/t3-rpi-config-script
cd t3-rpi-config-script
./imageBuild.sh -vcnprbi
To backup the image you created, insert the SD card into a device running linux with enough free storage space to comfortably hold the full size of your pi. Then find the device name by running sudo fdisk -l and looking for something like:
Disk /dev/sda: 14.9 GiB, 15931539456 bytes, 31116288 sectors
Disk model: STORAGE DEVICE
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 512 bytes
I/O size (minimum/optimal): 512 bytes / 512 bytes
Disklabel type: dos
Disk identifier: 0xafe59c2e
Device Boot Start End Sectors Size Id Type
/dev/sda1 8192 96663 88472 43.2M c W95 FAT32 (LBA)
/dev/sda2 98304 14434303 14336000 6.9G 83 Linux
in this case the device name is sda, and it has 2 partitions sda1 and sda2 to clone theis device into an image file use the command
sudo dd if=/dev/sda of=/home/pi/backup.img bs=1M progress=status
this will clone the device sda into the file backup.img in your home folder
To collect a shrinked image you can use the shrink.sh script hosted here: https://github.com/qrti/shrink
uses nice onscreem instructions and some light configuration. The extent of the configuation is finding your drive name using the fdisk -l trick from above, and inserting it into the shrink.sh file as described in their readme