docs: Note the release of v0.11.0

Signed-off-by: Kevin O'Connor <[email protected]>

docs/Releases.md

@@ -3,6 +3,31 @@
 History of Klipper releases. Please see
 [installation](Installation.md) for information on installing Klipper.
 
+## Klipper 0.11.0
+
+Available on 20221128. Major changes in this release:
+* Trinamic stepper motor driver "step on both edges" optimization.
+* Support for Python3. The Klipper host code will run with either
+  Python2 or Python3.
+* Enhanced CAN bus support. Support for CAN bus on rp2040, stm32g0,
+  stm32h7, same51, and same54 chips. Support for "USB to CAN bus
+  bridge" mode.
+* Support for CanBoot bootloader.
+* Support for mpu9250 and mpu6050 accelerometers.
+* Improved error handling for max31856, max31855, max31865, and
+  max6675 temperature sensors.
+* It is now possible to configure LEDs to update during long running
+  G-Code commands using LED "template" support.
+* Several micro-controller improvements. New support for stm32h743,
+  stm32h750, stm32l412, stm32g0b1, same70, same51, and same54 chips.
+  Support for i2c reads on atsamd and stm32f0. Hardware pwm support on
+  stm32. Linux mcu signal based event dispatch. New rp2040 support for
+  "make flash", i2c, and rp2040-e5 USB errata.
+* New modules added: angle, dac084S085, exclude_object, led, mpu9250,
+  pca9632, smart_effector, z_thermal_adjust. New deltesian kinematics
+  added. New dump_mcu tool added.
+* Several bug fixes and code cleanups.
+
 ## Klipper 0.10.0
 
 Available on 20210929. Major changes in this release: