Switching from motors tab and back resets the motor status

[dmak]

To Reproduce

• Go to Motors tab. Tick "I understand the risks" and start motors using "Master" slider.
• Switch to Power & Battery tab. In my case I needed to start motors to calibrate the current for medium throttle.
• Switch back to Motors tab.

Result

• There is motors hiccup. Probably due to tab initialization.
• "I understand the risks" is off, master slider is at zero (motors are still rotating).

Expected behavior

• There is no motors hiccup.
• "I understand the risks" is on, master slider (or individual motors) positions are remembered.

Configurator version

v10.10.0

[haslinghuis]

Define hiccup in relation to positions are remembered.
Following is before and after saving settings on power tab.

[dmak]

I have probably messed up with initial description. Try these steps:

• Switch on motors on "Motors" tab.
• Go to "Power & Battery" tab. Make tiny change e.g. to voltage and press "Save" (probably will work on other tab as well). Result: FC beeps and motors stop.
• Switch to "Motors" tab. "I understand the risks" is on, master slider is not zero (Betaflight thinks motors are rotating). Expected: master slider is at zero.

[nerdCopter]

i believe the motors tab is designed not to reset the motors (sliders) so that a pilot could use other tabs for viewing. especially useful is the sensors tab. however, the action of saving has corrupted the environment.

i wonder if resetting some global motor variable when MSP is saved would be a solution.

[haslinghuis]

@dmak pls check #4188

[dmak]

@dmak pls check #4188

So far looks good. Have to tried/checked switching between tabs when motors are on? Does it work smoothly?

[haslinghuis]

That part has not been changed.