Pedal Effects
Almost effects is trigger by simhub, so make sure the usb data connection from PC to esp32 is good.
The effects can be enable or disable by a simhub dashboard overlay or simhub actions binding.
ABS effect is trigger by telemetry dats through Simhub, some sims didnt provide the data(like WRC, DirtRally or GT series), the effects will not be triggered on those sims, alternative way was Wheelslip effect or simulated ABS effect.
TC effect is only can be trigger by telemetry data through Simhub, no alternative way for now.
Here is the demo video:
The Abs effect can be observed started from 5s.
The effect Amplitude value was recommend set 5% of the force range.
This option is for those sims didnt support ABS telemetry data output and didnt didnt support wheelslip calculation.
After enable the option, the red slider in Force-Travel curve will appear, the trigger value can be set via the slider.
Min value is 50%, Max value is 95% of total force output.
After enable the option, send config to pedal is needed, the simulated ABS effect calculated by ESP32, not simhub.
The effect simulate the vibration cause from engine cycle.
The effect amplitude will increase by the Engine RPM, when meet the max RPM, it will increase 30% of the set amplitude.
The amplitude was recommend set to 0.3-0.5% of total force range.
The effect min frequency is set to emulate the low RPM state, and max freqency is set when RPM reach to MAX value.
Here is the demo video:
The effect can be observed from the begining, the sled was move it self with oscillation.
If the sims didnt provide the data, alternative way is speed rumble option.