debug assert the output order of subcircuit

tket2/src/passes/tuple_unpack.rs

@@ -96,10 +96,31 @@ fn remove_pack_unpack<T: HugrView>(
     let mut nodes = unpack_nodes;
     nodes.push(pack_node);
     let subcirc = Subcircuit::try_from_nodes(nodes, circ).unwrap();
+    let subcirc_signature = subcirc.signature(circ);
+
+    // The output port order in `Subcircuit::try_from_nodes` is not too well defined.
+    // Check that the outputs are in the expected order.
+    if cfg!(debug_assertions) {
+        let tuple_type = Type::new_tuple(tuple_types.to_vec());
+        debug_assert!(
+            itertools::equal(
+                subcirc_signature.output().iter(),
+                tuple_types
+                    .iter()
+                    .cycle()
+                    .take(num_unpack_outputs)
+                    .chain(itertools::repeat_n(&tuple_type, num_other_outputs))
+            ),
+            "Unpacked tuple values must come before tupled values"
+        );
+    }
 
-    let mut replacement = DFGBuilder::new(subcirc.signature(circ)).unwrap();
+    let mut replacement = DFGBuilder::new(subcirc_signature).unwrap();
     let mut outputs = Vec::with_capacity(num_unpack_outputs + num_other_outputs);
 
+    // Wire the inputs directly to the unpack outputs
+    outputs.extend(replacement.input_wires().cycle().take(num_unpack_outputs));
+
     // If needed, re-add the tuple pack node and connect its output to the tuple outputs.
     if num_other_outputs > 0 {
         let op = MakeTuple::new(tuple_types.to_vec().into());
@@ -110,9 +131,6 @@ fn remove_pack_unpack<T: HugrView>(
         outputs.extend(std::iter::repeat(tuple).take(num_other_outputs))
     }
 
-    // Wire the inputs directly to the unpack outputs
-    outputs.extend(replacement.input_wires().cycle().take(num_unpack_outputs));
-
     let replacement = replacement
         .finish_prelude_hugr_with_outputs(outputs)
         .unwrap_or_else(|e| {