case document

dilemma_build_guide/max_v1.md

@@ -1,7 +1,7 @@
 ---
 layout: default
 title: MAX build guide
-nav_order: 6
+nav_order: 7
 parent: Dilemma Build guides
 ---
 

dilemma_build_guide/v2_case_installation.md

@@ -0,0 +1,53 @@
+---
+layout: default
+title: Case installation
+nav_order: 6
+parent: Dilemma Build guides
+---
+
+# Table of contents
+
+1. TOC
+{:toc}
+
+# Introduction
+
+If you have a case with your Dilemma or Dilemma MAX, on this page you will find instructions on how to install it.
+
+# Installing the spacers
+
+On the right side, for the trackpad assembly:
+
+-   screw the bottom 2 screws
+-   screw the top 2 Male/Female spacers
+
+![](../assets/pics/guides/dilemmacase/1.jpg)
+
+-   Screw in the Female/Female spacers
+-   Use the flat-headed black screws
+
+
+{: .tip }
+Depending on your kit, you might get either yellow or grey spacers. They work exactly the same, in the pictures we used the yellow ones.
+
+![](../assets/pics/guides/dilemmacase/2.jpg)
+
+For the left side, the process is the same - just use Female/Female spacers instead of the Male/Female ones.
+
+
+# Installing the case and acrylic
+
+Install the 3d printed case. You might have to push a bit so it fits well in the spacers.
+
+![](../assets/pics/guides/dilemmacase/3.jpg)
+
+- Install the acrylic on top
+- Make sure everything is flush
+
+![](../assets/pics/guides/dilemmacase/4.jpg)
+
+Install the bottom plate using the black chamfered screws.
+
+![](../assets/pics/guides/dilemmacase/5.jpg)
+
+Finally, install the anti-slip pads.