2.3

• add outside detrompeur for diodes
• update silkscreen to match new design guidelines (ish)

For assembly, use BOM and POS from release 2.1

2.2

• fix R2 connection to thumb cluster breaking sometimes
• wider flex connector
• fix C4R4 side PCB breaking sometimes (double connections)

For assembly, use BOM and POS from previous release

2.1b

This is a pre-release, use at your own risk.

• new edge cuts
• thinner columns
• rounded extremities
• space for assembled footprints
• same rgb footprint as 4x6
• fix trace settings - 0.13 and 0.3 per net, clearances as well. Double check with JLC 2 layer
• rgb: move middle vias away from middle... causing shorts...
• use 0402 or 0201 diodes, in clusters - eg. sod523 (C122862)
• make diodes reversible to enable double-sided RGB assembly
• emergency 1206 diodes on top of each switch
• cleanup
• bigger thermal reliefs for leds
• change silkscreen fonts to fira sans
• add very visible top/bottom labels for easier assembly
• make emergency diodes footprint slightly smaller
• add detrompeur to outside of emergency diode footprint
• place assembled capacitors
• place assembled resistors
• fix row numbering
• bigger switch holes for easier fitting
• slightly rounder corner on one of the column connectors

1.3

pic