Replies: 3 comments 10 replies
-
From the fields in the new value dialog, it seems like it's not the same as it was in z2m? :) |
Beta Was this translation helpful? Give feedback.
-
@LordMike Actually zwavejs doesn't support polling. Polling is not easy and @AlCalzone is speaking with a zwave expert to understand the best way to implement it |
Beta Was this translation helpful? Give feedback.
-
I'm aware that this might not be easy, but I really think this is an important feature. Especially som older devices would benefit from this, e.g. the Greenwave Powernodes: Being able to configure polling on individual endpoints (and with individual intervals) would be sooo cool. @robertsLando & @AlCalzone: Unfortunately, I'm not proficient enough to help on the actual coding - but I'd be happy to help searching through stuff and go all-in on testing ;-) Regards, |
Beta Was this translation helpful? Give feedback.
-
Back in Z2m, I had a polling setup where I polled one specific device's value. It comes online, but doesn't report any values, so I need to poll it .. :/
I managed to set up polling previously, using the gateway settings where I by some stroke of luck managed to click just enough buttons for something to work.
I can see the same settings in zwavejs2mqtt - but I'm not sure what to put where. The docs are a little lacking here :)
Sidenote
The dropdown with devices in the new-value dialog, does not include my device after a restart.. I thought it just needed to do its initial setup stuff to get all devices pinged, but even when other devices are in, this one isn't.
Current devices.
NorthQ Q-Gas 9121 has been "identified", and is in
RestartFromCache
state.Including node.json, for posterity node_4.json.txt
Beta Was this translation helpful? Give feedback.
All reactions