GD00Z-7 Garage Opener Doesn't Report State Automatically #6498
Replies: 5 comments 3 replies
-
|
👋 Hey @mostlychris! It looks like you attached a logfile, but its filename doesn't look like it a driver log that came from Z-Wave JS. Please double-check that you uploaded the correct logfile. If you did, disregard this comment. As a reminder, here's how to create one: |
Beta Was this translation helpful? Give feedback.
-
|
The bot is right, you uploaded the wrong logfile. |
Beta Was this translation helpful? Give feedback.
-
|
Followed the directions. Let me try again. |
Beta Was this translation helpful? Give feedback.
-
|
It was a Monday. I didn't scroll down to the driver log instructions. Doh! I've added the correct log now. |
Beta Was this translation helpful? Give feedback.
-
|
Has there been any thoughts on this? Polling the device every 10 seconds is causing issues in my network and potentially draining some of my battery devices. |
Beta Was this translation helpful? Give feedback.
-
|
Sorry, I must have missed that you posted the log. According to the manual, the device should have one association group which should contain the node ID of the controller. Please check in the groups tab that this is the case. If not, add it. I suspect there was an issue during the original interview, which prevented it from being added automatically. |
Beta Was this translation helpful? Give feedback.
-
|
After all this, power cycling the device seems to have fixed it. I also removed the group endpoint and re-added it. Might have taken both efforts. Thanks @AlCalzone for your help! |
Beta Was this translation helpful? Give feedback.
-
Checklist
I have read and followed the above instructions
I have checked the troubleshooting section and my problem is not described there.
I have read the changelog and my problem was not mentioned there or the fix did not work.
Describe the issue
I upgraded to the latest version of zwave js ui a few weeks ago and then started having issues with my GD00Z-7 garage door controller. I restored from backup and all was well. Fast forward to today when I upgraded HA and this rquired an update to zwave ui. I am now having issues again.
The opener shows healthy in the UI and I can send commands to open and close the door. What is not working is the reporting of door state (open/closed) unless I manually refresh the state in the UI. When I do that, it reports out to HA and shows the correct status in HA and the Zwave UI.
If I enable polling on the barrier state via the UI general settings page, it grabs the state correctly with each poll. Obviously this is not a long term solution as polling every 10 seconds is hard on the network.
What did you expect to happen instead?
The barrier state to update as soon as the state changes, as it has done in the past.
Steps to reproduce the behavior:
Upgrade to the latest version of the Z-Wave JS UI.
Open or close the garage door.
Observe that the barrier state did not update in the UI or anywhere else.
Manually refresh the Barrier Operator V1 section of the node and observe the barrier state reflect the current state of the door as well as update HA entities.
Anything else we should know?
This worked in versions of Zwave JS UI prior to t
Software versions
Z-Wave JS UI: 3.0.1
Device information
Manufacturer: Nortek Security & Control LLC
Model name: GD00Z-7
Node ID: 066
Checklist
I made sure to provide a driver log on level debug.
The log includes a re-interview of the problematic device (if applicable).
The log includes the problematic interaction with the device (if applicable).
I provided the node ID of the problematic device (if applicable).
Upload Logfile
z-ui_2023-11-06.log
Beta Was this translation helpful? Give feedback.
All reactions