no pool/spa heater

[eprst]

Hi. New user here.
I have RS6-combo, and for some reason I can't get pool and spa heater buttons to appear. SWG is also not properly reporting.

Serial logger output:

oot@pool(rw):~/AqualinkD/release# ./serial_logger /dev/ttyUSB0 
AqualinkD serial_logger V2.0
Notice:  RS Serial: Port /dev/ttyUSB0 low latency mode is set
Notice:  RS Serial: Logging serial information!
Please wait.|

Notice:  RS Serial: RS485 interface received 600 packets in 35 seconds (~17.14 Msg/Sec)
Notice:  RS Serial: Jandy Control Panel Model   : 
Notice:  RS Serial: Jandy Control Panel Version : 
Notice:  RS Serial: Jandy ID's found
Notice:  RS Serial: ID 0x40 is in use    <-- Onetouch device
Notice:  RS Serial: ID 0x30 is not used  <-- can use for Aqualinkd (Prefered Extended Device ID)
Notice:  RS Serial: ID 0x31 is not used  <-- can use for Aqualinkd (Prefered Extended Device ID)
Notice:  RS Serial: ID 0x32 is not used  <-- can use for Aqualinkd (Prefered Extended Device ID)
Notice:  RS Serial: ID 0x33 is not used  <-- can use for Aqualinkd (Prefered Extended Device ID)
Notice:  RS Serial: ID 0x48 is not used  <-- can use for Aqualinkd (RSSA ID)
Notice:  RS Serial: ID 0x49 is not used  <-- can use for Aqualinkd (RSSA ID)
Notice:  RS Serial: ID 0x60 is not used  <-- can use for Aqualinkd (PDA mode only)
Notice:  RS Serial: ID 0x61 is not used  <-- can use for Aqualinkd (PDA mode only)
Notice:  RS Serial: ID 0x62 is not used  <-- can use for Aqualinkd (PDA mode only)
Notice:  RS Serial: ID 0x63 is not used  <-- can use for Aqualinkd (PDA mode only)
Notice:  RS Serial: ID 0x08 is not used  <-- can use for Aqualinkd
Notice:  RS Serial: ID 0x09 is not used  <-- can use for Aqualinkd
Notice:  RS Serial: ID 0x0a is not used  <-- can use for Aqualinkd
Notice:  RS Serial: ID 0x0b is not used  <-- can use for Aqualinkd
Notice:  RS Serial: ID 0x41 is not used  <-- can use for Aqualinkd (Extended Device ID)
Notice:  RS Serial: ID 0x42 is not used  <-- can use for Aqualinkd (Extended Device ID)
Notice:  RS Serial: ID 0x43 is not used  <-- can use for Aqualinkd (Extended Device ID)
Notice:  RS Serial: 

Notice:  RS Serial: Suggested aqualinkd.conf values
Notice:  RS Serial: -------------------------
Notice:  RS Serial: device_id = 0x08
Notice:  RS Serial: rssa_device_id = 0x48
Notice:  RS Serial: extended_device_id = 0x30
Notice:  RS Serial: -------------------------

aqualinkd.conf.gz
aqualinkd.log.gz

Any ideas?
Thanks

[eprst]

PEBKAC, didn't notice default button label mappings at the bottom.