BLE Appears to have Brick ESP module

[Waz-Cpt]

Hello There,

I tried enabling BLE to connect the XIAOMI BLE temp humidity sensor (flashed with the ATC firmware) and the device is no longer connecting to the wifi, nor is it bringing up the fallback AP. I also cannot connect the device to do physical debug or reload firmware.

Any advice to either reset settings to defaults via hardware or any other suggestions would be appreciated.

[revk]

Just refreshing over USB to be honest.

[revk]

Can you provide a picture - there should be 4 pins to allow USB directly which should work anyway.

[Waz-Cpt]

Using the Esp32 S3 devkit c

[revk]

Ok sorry I thought it was a faikin board. In which case, sorry, no clue.

[Waz-Cpt]

Is it poosible that enabling BLE did something with GPIO0 or GPIO46?

[revk]

I really see no way it could, sorry.