Skip to content
New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

Input for ColorLight 5A-75B/E, by rewiring pin 1 of buffers to GND and powering with 3.3v? #105

Open
ericfont opened this issue Nov 21, 2022 · 5 comments

Comments

@ericfont
Copy link
Contributor

To use inputs for ColorLight 5A-75B/E, I was thinking what about rewiring a buffer IC's pin 1 (the direction pin) to disconnect it from Vdd and instead connect it to ground? It would require physically breaking pin 1's connection to the board cause the pin sits on Vdd rail. Then could carefully solder a wire to it and an exposed ground.

Would also need to power the entire board using 3.3V instead of 5.0V, since the FPGA pins are surely not 5V-tolerant. (The only things the positive rail powers are the buck converters, but according the data sheet the 3.3V buck converters can still work with 3.3V input...the output just can't be higher than the input.)

@ericfont ericfont changed the title Input for ColorLight 5A-75B/E, by rewiring pin 1 of buffers to and powering with 3.3v? Input for ColorLight 5A-75B/E, by rewiring pin 1 of buffers to GND and powering with 3.3v? Nov 21, 2022
@ericfont
Copy link
Contributor Author

The readme currently suggests to replace the buffer boards instead, but I wanted to suggest just physically rewiring pin 1 as a simpler solution (which requires less soldering and doesn't require buying a new chip).

@ericfont
Copy link
Contributor Author

I just wanted to note the downside of my suggestion is that once pin 1 has been physically rewired, it would be difficult to go back. Hypothetically one could instead rewire the pin to a physical switch. Or could even wire to an output pin from another output-only buffer, to allow that one wire to be selectively reconfigured by writing to that output pin.

@kittennbfive
Copy link
Contributor

Yes, this should work. However as you said the FPGA is certainly not 5V tolerant and i don't know if the entire board will work when powered with 3,3V (not familiar with this buck converter stuff).

@Peter-van-Tol
Copy link

It is worth to mention that the buffers (74HC245T) are not 5 V tolerant either when driving, so the peripherals should be also driven by 3.3 Volts in this case. A slightly less intervening method to convert the board, whilst being able to use 5 Volt inputs is to run the board from 3.3 Volt and replacing the buffers with 74LVS245. In this case you don't have tow rewire / cut the VCC to each chip you replace, making damages less likely to happen. You only have to cut the trace to the direction pin and rewire that to GND.

@stanleyseow
Copy link

Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment
Labels
None yet
Projects
None yet
Development

No branches or pull requests

4 participants