THB1 error writing boot

[mukowman]

I get the following error when trying to flash boot.
Tried different baud speeds and v16 vs v17 same error.

=========================================================
PHY62x2 Utility version 11.03.24
---------------------------------------------------------
Connecting...
PHY62x2 - Reset Ok
Revision: b'001364c8 6222M005'
FlashID: 1364c8, size: 512 kbytes
PHY62x2 - connected Ok
---- Segments Table -------------------------------------
Segment: 11003000 <- Flash addr: 00003000, Size: 00008f28
Segment: 1fff0000 <- Flash addr: 0000bf28, Size: 00000400
Segment: 1fff1838 <- Flash addr: 0000c328, Size: 00002bd6
----------------------------------------------------------
Erase All Chip Flash... ok
Segment Table[03] <- Flash addr: 00002000, Size: 00000130
Write 0x00000130 bytes to Flash at 0x00002000... ok
Segment: 11003000 <- Flash addr: 00003000, Size: 00008f28
Write 0x00002000 bytes to Flash at 0x00003000... ok
Write 0x00002000 bytes to Flash at 0x00005000... ok
Write 0x00002000 bytes to Flash at 0x00007000... ok
Write 0x00002000 bytes to Flash at 0x00009000... ok
Write 0x00000f28 bytes to Flash at 0x0000b000... ok
Segment: 1fff0000 <- Flash addr: 0000bf28, Size: 00000400
Write 0x00000400 bytes to Flash at 0x0000bf28... error!

[rumpelrausch]

I had the same problems. Just try again, it may work eventually.

[pvvx]

1. Check the thermometer's power supply.
2. The USB-COM adapter must have 3.3V outputs.