Feature report 0xF7

Note: This information applies only to the old CECH-ZCM1 models, not the newer CECH-ZCM2 models.

Byte offset	Description
0x00	HID Report ID (always 0xF7)
0x01	battery OSD status (same as battery level in Input Report)
0x02	lower byte of battery voltage (as measured by the ADC)
0x03	higher byte of battery voltage (as measured by the ADC)
0x04	lower byte of temperature value (raw ADC value plus adjustable offset)
0x05	higher byte of temperature value (raw ADC value plus adjustable offset)
0x06	0x00 if output pin PC12 is set, 0x01 otherwise
0x07	0x01 if input pin PC10 is set, 0x02 if input pin PC11 is set, 0x03 if both are set, 0x00 otherwise
0x08	always 0x00
0x09	always 0x00
0x0A	always 0x00
0x0B	always 0x00

bq24080 Li-Ion charger IC

The MCU's output pin PC12 is connected to the charge enable input of the bq24080 Li-Ion charger IC. Pulling this input low enables charging the battery. Byte 0x06 in the Feature Report will thus be zero if no charging is in progress.

The MCU's input pins PC10 and PC11 are connected to the bq24080's charge status outputs. The following table translates the values in the Feature Report into the corresponding status:

Report's byte 0x07	Charge status
0x00	Precharge in progress
0x01	Charge done
0x02	Fast charge in progress
0x03	Timer fault or sleep mode