Skip to content

MIDI event scripting file format

spamatica edited this page May 25, 2020 · 4 revisions

MusE midi event scripting format 0.7

INTRODUCTION

MusE supports a simple protocol for manipulating event data.

SPECIFICATION

The format of the scripts is just a set of text lines which deliberately has been kept very brief and should be possible to handle from any programming language, Python, Perl, C/C++, even shell script. Though for faster development an interpreted language is probably recommended.

There are two main requirements on scripts.

  1. the actual script file must have the executable flag set, that is, it must be considered an executable from the perspective of the operating system (chmod +x <script file>).
  2. a script takes it's input from a file given as argument and will send it's output to the same file.

The tags that may occur in the file sent to the script are currently:

  • TIMESIG <n> <z>
  • PART <part start> <part length>
  • PARTLEN <length in ticks of the current Part>
  • BEATLEN <length in ticks of a beat>
  • QUANTLEN <length in ticks of the current quantization>
  • NOTE <tick> <pitch> <length in ticks> <velocity>
  • CONTROLLER <tick> <a> <b> <c>

TIMESIG, PARTLEN, BEATLEN and QUANTLEN are there for informational purposes, to make some transformations possible. e.g. quantization, beat delay.

NOTE and CONTROLLER are the ones that are read back into MusE when the filter stops executing. These may be manipulated, removed or multiplied as seen fit by the filter.

  • Note that it is generally a good idea to just pass on the lines your script is not interested in, otherwise data may be unintentionally removed

INSTALLATION

Scripts can be put in two different dirs:

  • <install_path>/share/muse/scripts

for scripts bundled, or:

  • $HOME/.config/MusE/MusE/scripts

for user created scripts

Remember that a script must have the executable bit set. This means that the script must be executable -on it's own-. For an interpreted language that means the file should start with a hashbang (#!) and the path to it's interpreter. e.g

#!/usr/bin/python

EXAMPLE DATA

A short example of input data:

TIMESIG 4 4

PART 6144 6144

BEATLEN 384

QUANTLEN 96

NOTE 1536 65 96 70

NOTE 2400 69 96 70

EXAMPLE FILES

There are a few existing scripts in this directory that can be used as templates for creating more advanced scripts.

  • DoNothing - just reads the input file, loops through the lines and outputs them again.
  • DoubleSpeed - reads all notes and outputs them with all ticks divided in half.
  • RemoveShortEvents - a script with a GUI in PyQt which removes events shorter then the set note length

For the moment there are only scripts written in python in the standard installation.

DEBUGGING

The process of debugging a script may seem daunting. There is no immediate way to retrieve information about the internals of the script.

Currently the standard output is suppressed from the scripts so while running from MusE the script won't make a peep in the console. if MusE is started with -D argument the contents of the data file is written to standard out both before it enters the script and after it returns, this can be used as a means for communication. The file containing the script data is normally removed but when running MusE with -D it will be kept. So, when the file exists you can use it and run the script from a command line, remember though that the file will be overwritten by the script.

Running the script like this makes it a bit easier (with data and a test script in the same folder):

cp origData testData && ./MyTestScript testData

Then the data can be compared to the original and prints in the script can be read on the commandline.

END

Clone this wiki locally