Contact

[Fragmon]

Hello. We create the klipper firmware for the anycubic vyper. He has a strain gauge too. How can we contact you? We would help.

[jerryngm]

If the printer used a dedicated board to connect to the Z- Endstop on the motherboard then you can enter that pin to your Klipper config file as probe or virtual Z end

[Fragmon]

Do you have a pinout for the chip or the source for the Marlin? I only found for the neptune 2. And i wont messure all traces. I am searching on the marlin github, but they dont add this cloneboard. Where you get the pins for klipper?

[jerryngm]

If the manufacturer published the source code for Marlin then you can find it in the Pins src file, otherwise you can try your luck by looking up the board name, they tend to clone from other manufacturers. I owned an Anycubic product previously and they don’t tend to open source their products

[Fragmon]

Anycubic open the marlin source for the vyper and i need that for the neptune because i need a few pins.

[jerryngm]

You can find source code for Neptune 3 here
https://github.com/NARUTOfzr/Neptune_3

[Fragmon]

I am blind thank you :-D