Programmable only after desoldering resistor PLL R118

[Yarulik]

Hello dears!
I finally got around to getting this wonderful microphone out of my long drawer.
I checked everything many times, all the well-known recommendations, and found out that resistor R118 blocks XMOS programming.
Having unsoldered it, I was able to flash 16SoundsUSB_Firmware_REV_1_0.xe, the equipment appeared in the system, but the microphones did not work.
If you solder R118 (0R), the controller freezes and does not initialize. The oscillator produces exactly 24 MHz. Я использую XEF216-512-TQ128-C20
15th xflash:

xflash 16SoundsUSB_Firmware_REV_1_0.xe 
Site 0 has finished successfully.

14th xflash:

Warning: F03098 Factory image and boot loader cannot be write-protected on flash device on node 0
xflash: Warning: F03148 --quad-spi-clock not given, using default 15.62MHz
xflash: Warning: F03149 QE_REGISTER and/or QE_BIT locations not found in XN file for this flash device. Using default flash_qe_location_status_reg_0 and flash_qe_bit_6.
Warning: F03150 The use of libquadflash will be deprecated from XFLASH in xTIMEcomposer 15.0.0.
Please add the PageSize, SectorSize and NumPages attributes to your External Device definitions in your target XN file to enable the use of lib_flash.
Site 0 has finished successfully.   

What could be my mistake?