You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I connected an e-ink display to the gpio-pins. And nothing happened eventhough i tried all epd-settings in the config.json.
So i downloaded demos from Waveshare, and it seems that my version of display is "epd2in13g".
This because their python-example epd_2in13g_test.py makes my screen function (noteworthy, with 8-pin connector).
It doesnt seem that bjorn works with this "g"-type, am i doing something wrong, or is it just not supported at the moment?
Im testing on a pi zero 2 w.
The text was updated successfully, but these errors were encountered:
I have a rev 2.1 with Pi Zero 2W.
Looks like 2.1 is a V3. So I've selected "v3" while installing. In addition to that, before the first reboot right after the installation, I've enabled SPI and I2C though the raspi-config. Then it worked like a charm.
Note: My rev 2.1 is connected to Pi Zero 2W via GPIO mount.
I connected an e-ink display to the gpio-pins. And nothing happened eventhough i tried all epd-settings in the config.json.
So i downloaded demos from Waveshare, and it seems that my version of display is "epd2in13g".
This because their python-example epd_2in13g_test.py makes my screen function (noteworthy, with 8-pin connector).
It doesnt seem that bjorn works with this "g"-type, am i doing something wrong, or is it just not supported at the moment?
Im testing on a pi zero 2 w.
The text was updated successfully, but these errors were encountered: