Skip to content

Latest commit

 

History

History
95 lines (65 loc) · 2.5 KB

README.md

File metadata and controls

95 lines (65 loc) · 2.5 KB
Raw

ES688F / OPL3 8bit ISA Sound Card

Introduction

This is a sound card for the ISA 8bit bus sporting the ES688F chip by ESS Technology and the YMF262 chip by Yamaha, also known as the OPL3.

This board provides selectable Sound Blaster PRO / Sound Blaster emulation and OPL3 compatibility.

It's completely jumper-configurable, requiring no software except the essvol utility to set the volume.

Rev. 1.1 Board

This board provides the following connections:

  • Speaker out (amplified)
  • Line out
  • Line in
  • Aux in (internal header)
  • Microphone in (internal header)
  • Joystick port
  • MIDI on Joystick port
  • Volume regulation pot

Disclaimer

I take NO responsibility for what happens if you decide to build and use this card. Your computer might crash, catch fire or be destroyed in other nasty ways. You're encourauged to take what you deem fit from this, and use it in your projects!

Functionalities

✅ means I tested the functionality and it works, ❌ means I tested the functionality and found issues, ? means that the functionality has yet to be tested.

  • [✅] FM Synthesis via OPL3
  • [✅] Digital audio playback
  • [?] Stereo (left/right channel) check
  • [✅] Joystick port
  • [✅] Speaker Out (amplified)
  • [✅] Line out
  • [✅] Line in
  • [?] AUX In
  • [?] Microphone in
  • [✅] MIDI output via Joystick port

The card was tested on:

  • [✅] NEC V20 9.5Mhz / DOS 6.22
  • [✅] SUNTAC 286 12Mhz motherboard / DOS 6.22

Configuration

This card is configured via jumpers.

  • JP1: Selects the Sound Blaster emulation mode
    • 1-2: Sound Blaster (DSP v2.11)
    • 2-3 Sound Blaster PRO (DSP v3.1)

The following jumpers must me insalled vertically in the block. 1 means Jumper Present, 0 means Jumper Absent.

  • J2: Selects the IRQ:

    • 00: IRQ2
    • 10: IRQ5 (default)
    • 01: IRQ7
    • 11: IRQ3

  • J3: Selects the I/O address:

    • 00: 220h (default)
    • 10: 230h
    • 01: 240h
    • 11: 250h

  • J4: Selects the DMA channel

    • 00: None
    • 10: DMA2
    • 01: DMA1 (default)
    • 11: DMA3

    WARNING: /DACK2 and DRQ2 lines are disconnected and must be jumpered on the backside of the board if used, by bridging JP3 and JP2.

Bill of Materials

TODO

Known Issues

Rev 1.1

  • Missing silkscreen to describe JP1

Rev 1.0

  • Wrong footprints for YAC512 and YMF262 chips
  • Volume pot placed after audio decoupling. Wrong.

Credits

Thanks to Sergey Kiselev for his symbol/footprint library!