- 6 x M2x8mm screws
- 10 x M2x6mm screws
- 6 x M2x6mm (OD3.2mm) insert
- 10 x M2x3mm (OD3.2mm) insert
- ~50 1N4148 SOD-123 Diode
- 10 x 2.5mm Rubber Plug
- 10 x ID 3mm OD 6mm, CS 1.5mm O-rings
- 4 x 20x4x1.5mm Silicone rubber feet
- 14 x WS2812B 5050 RGB LED
- Pro Micro TYPE-C USB 3-6V Check right model, bigger one won't fit nicely.
- Soldering iron and solder
- Hex screwdriver
- Flush side cutters
- ~50 MX style switches
- 3 x 2u PCB mount stabilizers
- Keycaps (check compatibility)
Connect Pro Micro to computer and flash "kolibrimini_default.hex" firmware using qmk toolbox
Pcb
Solder diodes for all keys. Stripe on diode to square pad on pcb
For rgb leds !!Check that led is correct way!! (triangle goes top left).
Solder Pro Micro to top side of pcb. Check that pins match.
Now it's good time to test pcb. Connect it to your computer and use tweezers to test keys.
Solder switches and add stabilizers. Add rubber plugs from bottom of pcb.
Use something like small screwdriver or tweezers to get rubber plugs through hole. Now you can place O-rings to top.
MJF printed case
Place 6 x 6mm brass inserts to case. I had to use alot of force to get them there. Hole size of the model is fine, but there was some shrink from printing.
Acrylic (3mm) backplate
Place 10 x 6mm screws from bottom of backplate. Then add 3mm brass inserts.
Time to assemble
