More than 4 individual entities.

[incarvr6]

Is there any chance to make visible more than 4 individual entities. Currently it is limited to only 4, so I was wondering if this can be changed in future?

[WyndStryke]

I'd like this also, although a) obviously the card could end up very cramped, and b) this is going beyond the original scope quite significantly.

Maybe the top 4 of a list rather than trying to display them all at the same time.

My personal use-case is that I'm using the 'individual' entries to represent rooms, each room is a combination of all the individual devices within that room (implemented via 3 helpers per room, a couple of template sensors and one utility meter per room, to get power into the primary, and the room's daily kWh into the secondary info). Maybe it's possible to implement the 'top 4' via templates and utility meters rather than doing it in the card, not sure how to do that though.

[incarvr6]

Yeah well if it is used without Grid input, there is room for two more

[WyndStryke]

The way I have it set up is like this:

The numbers won't make sense right now because the circuit CT clamps aren't actually connected yet, but that's the idea.

Not sure how to change the captions on the 'devices' entries dynamically. If I knew how to do that, then I think I could do the 'top #4' approach via templates etc.

[incarvr6]

Yeah, that is actually a good way to see room consumption.
Your idea for showing top 4 individual consumption is great.

Let's hope that something can be done to increase maximum individual consumers.

[titilambert]

I was thinking to suggest a thing which could be group of individuals. The objective would be to group the individuals per floor/zone/area/domain/breaker in order to drill down and see what is consuming what ...
Something like a forced directed tree with expandable/collapsible nodes https://www.amcharts.com/demos/force-directed-tree/)

or

[WyndStryke]

Interesting, it's analogous to a Sankey diagram but radial rather than linear