README.md

RaspberryPi_Car_Project

Components:

- Raspberry pi

- 4 electric motors with wheels (the ones sold for Arduino are the same)

- Dual H Bridge Stepper Motor Drive Controller Board

- Batteries and a baterry pack

- External recharger for the pi

- Cables

- Something to make the frame such as thick cardboard

- Duct tape

Solder the cables to the electric motors

Connect the battery to the bridge as well as have an extra cable to connect the ground to the Raspberry Pi

Cut a a rectangle-shaped cardboard piece to use it as a frame and place the motors on it and make holes to pass the cables to the upper section.

Connect the motor cables to the bridge which is connected to the baterry

Lastly connect the Raspberry pi with the bridge as shown, using the 4 "IN" pins to control the wheels and make sure you have an external power supply that gives enough voltage for the pi.

When finished using it, make sure you remove one of the baterries from the baterry pack to prevent drainage

=======