Shelly 2pm gen3 supported?

[joba-1]

Anyone successfully used this device with tasmota? Which template?

I searched Blackadders site and here and found close matches, but not exactly this one (2 relays with power moni, small)

According to the following link it uses an ESP-Shelly-C38F with 8MB flash.

https://kb.shelly.cloud/knowledge-base/shelly-2pm-gen3

[arendst]

Search the source code for the template. It works fine since months with tasmota.

Oops. No sorry. Haven't tested it yet.

[arendst]

Looking at the shelly specs I don't see why Tasmota this doesn't support already. It just needs someone to find the correct GPIO's and power monitoring hardware.

BTW Shelly is gone bunkers with regards to pricing; this device sells for 32,55 excl shipping. Their Dali Dimmer, in October 38,- now is 54,- and out of stock.

[joba-1]

I think I bite the bullet this time - free market at work. Couldn‘t find another device that small and every mm counts.

[arendst]

Yesterday I ordered latest gen3 stuff from proshop (demark). It'll take more time to receive but the prices are a lot lower than shellies.

[Jason2866]

Currently some Shelly devices are on Sale on Amazon

[arendst]

Try this:

{"NAME":"Shelly 2PM Gen3","GPIO":[1,4736,576,225,3456,224,640,608,1,1,193,0,0,0,0,0,0,0,192,32,1,1],"FLAG":0,"BASE":1}

with adcgpio1 32000,10000,3350

[joba-1]

please, how did you flash it?

Yesterday I tried -|Rx|Tx|3V3|-|Gnd|Gnd found for older version.
Switched Rx and Tx, also changed direction.

Used an usb adapter that can usually deliver enough power for ESP32 dev boards.

There was short flashing of rx/tx leds of the adapter on connection, but no response after that. Also no AP coming up.

Since testing time was up, for now it operates with the original firmware and works fine.

[Noschvie]

Did you connect GPIO0 to GND? Or try to use mgos32-to-tasmota32.

[joba-1]

if the pin assignment I used is correct, yes.
I‘ll try more, probably next week