Spikeclient.Spikeerror - this error is causing Loop to freeze and can be difficult to recover

[JELCRAWFORD]

No description provided.

[JELCRAWFORD]

Repeat error tonight - june30- same dropout tonight. I tried killing Spike, without resolution.

Then I killed both Spike and Loop, also without resolution.

In the pod menu I checked the Rileylink connection =-59dB. I also ran a test command = “succeeded”.

Spike and Loop are both in the “always allowed” category in ScreenTime.

Finally, I placed the RL on DS belly beside the Pod and the red loop began to wiggle and turned green.

This was an easier resolution than yesterday, which took 2+ hours. Tonight was around 30 minutes, with about 15 active minutes trying to resolve. Would be good to know what’s up though.

When I started (at the 15 min warning of loop not being active, the RL and phone were on DS bedside table about 2 feet away from him. pod on his belly, under a blanket and pj shirt but otherwise unencumbered.

FYI this is a cross posting to Facebook for Spike.