You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Hello. Sorry, I am not sure if I am posting this issue in the correct place. I have just got my ViVi. After assembling I connected pcb to power supply. For a while I had power and a red led was up (on the power supply device) but I was not able to get if on wifi range. During this period servo motors started to moved randomly. After few minutes (I tried to switch on/off pcb to check if wifi could find ViVi...) red light was off and no signal that pcb is active. I tried to connect to other sockets but pcb seems dead. Any idea about that? thanks in advance
The text was updated successfully, but these errors were encountered:
Hi
same issue. Once firmware is loaded, the servo connected to PWM that are driven by Adafruit library is fine. The two servo connected to GPIO (driven by Servo library) are randomly moving.
Hello. Sorry, I am not sure if I am posting this issue in the correct place. I have just got my ViVi. After assembling I connected pcb to power supply. For a while I had power and a red led was up (on the power supply device) but I was not able to get if on wifi range. During this period servo motors started to moved randomly. After few minutes (I tried to switch on/off pcb to check if wifi could find ViVi...) red light was off and no signal that pcb is active. I tried to connect to other sockets but pcb seems dead. Any idea about that? thanks in advance
The text was updated successfully, but these errors were encountered: