2.0.9.3 Ghost 5 Issues

[rodrigosclosa]

I just updated my Ghost 5 (with Robin Nano V1.3 and TMC2208 drivers) from stock firmware to 2.0.9.3 and I'm getting 3 issues:

1. The printer is restarting on the middle of a print... It starts beeping like a thermal runaway and restarts it selfs...
2. Frequently I'm getting a thermal runaway halt from E1 after some parts that takes a few hours to print...
3. The print resume don't work... It got E1 and Bed hot, start to move the print head and stops right the position to print and stays on it... It dont start to print or extrude filament... I let it over 1 hour and nothing happens... If I try to cancel the print by Stop Print menu, nothing happens too, the print dont stops and I need to power cycle the printer to cancel it....

Thanks for your help!

[UPDATE]
Look at this video: https://share.icloud.com/photos/0a0re6n9rEEaXof6VcX1IB04Q
This is supposed to be a 12h hour print, it was printing gratefully... On some point, it stops printing and got this problem...

[williangomesa]

It happened to me too, sometimes I've got the same error messages.