Skip to content

Latest commit

 

History

History
63 lines (42 loc) · 2.03 KB

README.md

File metadata and controls

63 lines (42 loc) · 2.03 KB
Raw

THIS IS THE FREEPAD MOD - https://github.com/diyruz/freepad

Features list:

  1. Single/double/tripple/quadriple/many_x/hold&release
  2. ONOFF bind
  3. Level control bind
  4. Bindings configuration
  5. Remote reset
  6. Touch link

How to join:

If device in FN(factory new) state:

  1. Press and hold JOIN button for 2-3 seconds, until device start flashing led
  2. Wait, in case of successfull join, device will flash led 5 times
  3. If join failed, device will flash led 3 times

If device in a network:

  1. Hold JOIN button for 20 seconds, this will reset device to FN(factory new) status
  2. Go to step 1 for FN device

How to use touch link

  1. Bring you remote near to TL device
  2. Hold button (1) for 10 seconds TL funtionality can work without connecting to network

How to add device into zigbe2mqtt

Should be already in dev branch (as of 19-05-2020)

Work modes

By default remote works as custom swith, with multiple clicks, this behaiviout has own drawback. In order to detect multiple clicks, remote sends commands with 300ms delay. You can change this behaviour by cost of double/tripple/etc clicks. To do that you need to change

ZCL_CLUSTER_ID_GEN_ON_OFF_SWITCH_CONFIG cluster ATTRID_ON_OFF_SWITCH_TYPE attribute

Values are:

ON_OFF_SWITCH_TYPE_MOMENTARY (0) -> no delay, but no multiple clicks, only single

mosquitto_pub -t "zigbee2mqtt/FN/BUTTON_NUM/set/switch_type" -m '0'

ON_OFF_SWITCH_TYPE_MULTIFUNCTION (2) -> 300ms delay, full set of clicks

mosquitto_pub -t "zigbee2mqtt/FN/BUTTON_NUM/set/switch_type" -m '2' (default)

ONOFF cluster binding

By default command is TOGGLE, but you can change this behaviour

Change ZCL_CLUSTER_ID_GEN_ON_OFF_SWITCH_CONFIG clusters attribute ATTRID_ON_OFF_SWITCH_ACTIONS

ON_OFF_SWITCH_ACTIONS_ON

mosquitto_pub -t "zigbee2mqtt/FN/BUTTON_NUM/set/switch_actions" -m '0'

ON_OFF_SWITCH_ACTIONS_OFF

mosquitto_pub -t "zigbee2mqtt/FN/BUTTON_NUM/set/switch_actions" -m '1'

ON_OFF_SWITCH_ACTIONS_TOGGLE (default value)

mosquitto_pub -t "zigbee2mqtt/FN/BUTTON_NUM/set/switch_actions" -m '2'