Recovery from runout or pause function fails

[portudork]

Whenever I pause a print to change filament or trip the filament runout sensor the printer fails to resume printing (extruding filament) upon resume. The print head goes back to the last spot before pause but doesn't extrude any filament anymore while the print head moves effectively ruining any print. The pause and runout function are effectively useless due to this issue.

[NARUTOfzr]

This is because the slicing file uses extrude relative mode, which is not applicable to the firmware of the machine. You can try the following changes:

Or try updating firmware V1_1.0.5-beta

[portudork]

Do you mean to uncheck that setting and remove that g code? By default it's checked and that code is already in there.

[NARUTOfzr]

Yes. This is not the configuration file uploaded by elegoo. It does not match the machine. Extrusion relative mode should not be used.

…

---Original--- From: ***@***.***> Date: Wed, Jan 4, 2023 12:59 PM To: ***@***.***>; Cc: ***@***.******@***.***>; Subject: Re: [NARUTOfzr/Neptune_3] Recovery from runout or pause functionfails (Issue #55) Do you mean to uncheck that setting and remove that g code? By default it's checked and that code is already in there. — Reply to this email directly, view it on GitHub, or unsubscribe. You are receiving this because you commented.Message ID: ***@***.***>

[portudork]

And delete out the G92 E0 as well right? Over you confirm I'll do both and retest as soon as this print is done. Thanks for the quick response!

[NARUTOfzr]

yes. You can also comment out this line by adding ";" before it.

…

---Original--- From: ***@***.***> Date: Wed, Jan 4, 2023 13:19 PM To: ***@***.***>; Cc: ***@***.******@***.***>; Subject: Re: [NARUTOfzr/Neptune_3] Recovery from runout or pause functionfails (Issue #55) And delete out the G92 E0 as well right? Over you confirm I'll do both and retest as soon as this print is done. Thanks for the quick response! — Reply to this email directly, view it on GitHub, or unsubscribe. You are receiving this because you commented.Message ID: ***@***.***>

[TheAussieTinker]

I have done what you said, unchecked use relative e distance and commented out all G92 E0 lines in the gcode on PrusaSlicer. However when I open the gcode file PrusaSlicer has injected heaps of G92 E0 throughout the file that aren't commented out.