Enclosure USB cut out does not line up

[neilrees]

I'm not sure if all D1 Mini boards are made equal, but the Wemos Lolin D1 Mini has the micro-usb port mounted on the top of the board when the A0 pin is on the left and D4 is on the right, the orientation required by the Power Sensor PCB.

In that orientation the micro-usb port does not line up with the cut out in the enclosure, the cut out lines up with where the port would be if the USB port were on the bottom of the board.

Would it be possible to add the CAD files for the enclosure to the repository to allow for easier editing?

[Mottramlabs]

Hi Neil Is this the board https://docs.wemos.cc/en/latest/d1/d1_mini.html ? It appears the USB socket is on the opposite site to the D1 boards I have been using. The case was done using Freecad, I'll upload the files to Github and Thingiverse. Regards David

…

On Thu, 19 Mar 2020 at 19:27, Neil Rees ***@***.***> wrote: I'm not sure if all D1 Mini boards are made equal, but the Wemos Lolin D1 Mini has the micro-usb port mounted on the top of the board when the A0 pin is on the left and D4 is on the right, the orientation required by the Power Sensor PCB. In that orientation the micro-usb port does not line up with the cut out in the enclosure, the cut out lines up with where the port would be if the USB port were on the bottom of the board. Would it be possible to add the CAD files for the enclosure to the repository to allow for easier editing? — You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub <#2>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AB67J6CYWDYURMYSPGCHFILRIJW3HANCNFSM4LPSMCZA> .

[neilrees]

Yes that's the exact one.
Much appreciated. I'll see if I can flip the port over, if I can I'll send you a Pull Request.

[Scoff123]

Just stumbled upon this while searching for a way to make my own power monitor for HA. I have a few spare Wemos Lolin D1 Mini v4.0.0 boards which have a USB-C port. Exactly as per the above link. Will this board work correctly with the pin layout of the power sensor board? Is it just the case that requires modifying, and if so, @neilrees - did you manage to create a suitable case with correct opening? Appreciate this post was a while ago...