[BUG] enabled LCD_BED_TRAMMING not working

[freek-heining]

Did you test the latest bugfix-2.1.x code?

Yes, and the problem still exists.

Bug Description

I moved from regular 2.1 to bugfix 2.1 and compiled my firmware succesfully for my Ender 3 Pro.
Sadly the only thing not working is the bed tramming wizard in the menu, which I used a lot in the regular 2.1.
The wizard/option is just nowhere to be found. I reflashed several times and resetted the EEPROM etc.

// Add a menu item to move between bed corners for manual bed adjustment
#define LCD_BED_TRAMMING

#if ENABLED(LCD_BED_TRAMMING)
  #define BED_TRAMMING_INSET_LFRB { 30, 30, 30, 30 } // (mm) Left, Front, Right, Back insets
  #define BED_TRAMMING_HEIGHT      0.4        // (mm) Z height of nozzle at leveling points
  #define BED_TRAMMING_Z_HOP       4.0        // (mm) Z height of nozzle between leveling points
  #define BED_TRAMMING_INCLUDE_CENTER       // Move to the center after the last corner
  //#define BED_TRAMMING_USE_PROBE
  #if ENABLED(BED_TRAMMING_USE_PROBE)
    #define BED_TRAMMING_PROBE_TOLERANCE 0.1  // (mm)
    #define BED_TRAMMING_VERIFY_RAISED        // After adjustment triggers the probe, re-probe to verify
    //#define BED_TRAMMING_AUDIO_FEEDBACK
  #endif
    (examples omitted)
  #define BED_TRAMMING_LEVELING_ORDER { LF, RF, RB, LB }
#endif

Bug Timeline

New bug. Today

Expected behavior

The bed tramming wizard appearing in the main menu.

Actual behavior

It's not showing up.

Steps to Reproduce

Uncomment #define LCD_BED_TRAMMING to enable

Version of Marlin Firmware

2.1.2.4

Printer model

Ender 3 Pro

Electronics

SKR E3 mini v2.0

LCD/Controller

No response

Other add-ons

No response

Bed Leveling

No Bed Leveling

Your Slicer

Cura

Host Software

None

Don't forget to include

• A ZIP file containing your Configuration.h and Configuration_adv.h.

Additional information & file uploads

Marlin.zip

[thisiskeithb]

This was changed in #27393

You need to enable MESH_BED_LEVELING for the menu to show up.

[freek-heining]

This was changed in #27393

You need to enable MESH_BED_LEVELING for the menu to show up.

Thank you it worked!
I Googled a lot before asking this question but found nothing. Also it was not clear for me by reading the comments in the config file.

[thisiskeithb]

This needs to be fixed or sanity checked, so the issue should remain open.