From 8e92503fc5f6d45c235209d883a9c16df7c6d004 Mon Sep 17 00:00:00 2001 From: NokkOnEffect Date: Wed, 11 Dec 2024 21:26:26 +0100 Subject: [PATCH] update docs --- docs/Config_Reference.md | 11 +++++++---- 1 file changed, 7 insertions(+), 4 deletions(-) diff --git a/docs/Config_Reference.md b/docs/Config_Reference.md index 85947b7d9..fe19ae199 100644 --- a/docs/Config_Reference.md +++ b/docs/Config_Reference.md @@ -3518,14 +3518,17 @@ control: curve # fan would run with 0.5 at 55°) #cooling_hysteresis: 0.0 # define the temperature hysteresis for lowering the fan speed -# (temperature differences to the last measured value that are lower than -# the hysteresis will not cause lowering of the fan speed) +# (in simple terms this setting offsets the fan curve when cooling down +# by the specified amount of degrees celsius. For example, if the +# hysteresis is set to 5°C, the fan curve will be moved by -5°C. This +# setting can be used to reduce the effects of quickly changing +# temperatures around a target temperature which would cause the fan to +# speed up and slow down repeatedly.) #heating_hysteresis: 0.0 # same as cooling_hysteresis but for increasing the fan speed, it is # recommended to be left at 0 for safety reasons #smooth_readings: 10 -# the amount of readings a median should be taken of to determine the fan -# speed at each update interval, the default is 10 +# This parameter is deprecated and should no longer be used. ``` ### [fan_generic]