Erron in PAUSE function and M600 Error in Gcode comand

[artsitemail]

I tested this firmware, but the m600 command in gcode doesn't work, when it stops to change filament it stays waiting after resuming in the screen.
Another error is when PAUSE during printing, the printer does not print again, and if you cancel printing it Frezzes.

[TomasekJ]

Hi, thank you for the respond, you can try this fw: https://github.com/ queeup-Forks/Ender-3V3-SE_Marlin/releases

…

---------- Původní e-mail ---------- Od: artsitemail ***@***.***> Komu: CrealityOfficial/Ender-3V3-SE ***@***.***> Kopie: Subscribed ***@***.***> Datum: 30. 11. 2024 0:54:17 Předmět: [CrealityOfficial/Ender-3V3-SE] Erron in PAUSE function and M600 Error in Gcode comand (Issue #5) " I tested this firmware, but the m600 command in gcode doesn't work, when it stops to change filament it stays waiting after resuming in the screen. Another error is when PAUSE during printing, the printer does not print again, and if you cancel printing it Frezzes. — Reply to this email directly, view it on GitHub (#5), or unsubscribe (https://github.com/notifications/unsubscribe-auth/BKB6WR4FAWX2XYV2MNLHOHT2DD5CNAVCNFSM6AAAAABSX423HKVHI2DSMVQWIX3LMV43ASLTON2WKOZSG4YDMNBRGU3TGNQ) . You are receiving this because you are subscribed to this thread. Message ID: ***@***.***> "