Subscription Management

[techch01]

Hello,

As I want to manage a scope of subscriptions, how can I exclude subscriptions and then see the list of excluded subscriptions ?

Thanks.
Best regards,

[DCMattyG]

Hi @techch01, thanks for reaching out!

In the IPAM, you can navigate to the "Subscriptions" section under "Admin". Here, you'll find a list of all the subscriptions and you can click on the ones you'd like to exclude (this turns them red). When done, click the "save" button in the upper right.

Screenshot:

Hope that helps, please let us know if you have any problems at all!

[techch01]

Hi @DCMattyG

It is OK. Thanks for your return.

[techch01]

Hi @DCMattyG,

When a subscription is excluded, that is mean that its Vnets/subnets/Endpoints are not discoverd by the IPAM, isn't it ?

Thanks in advance?

[DCMattyG]

Hey @techch01, it's strange because in the screenshot above, it doesn't appear that the browser even navigated to the Subscriptions page (I can't see the address bar). Could you perhaps try in another browser just to verify this behavior is consistent?

[techch01]

Hi @DCMattyG,

Please to find below the screen :

I have changed the brower and I have the same result.

Please to find below the Network trace of URL "https://name_webapp.azurewebsites.net/admin/subscriptions"

Thanks in advance.

Best regards,
Tariq ECHCHAITAM

[DCMattyG]

This is indeed strange. It's getting back a 200 OK, but not showing the table (for some reason).

Can you try restarting your App Service in Azure? I just tested this with one of my deployments and I'm not seeing the same behavior. That certainly doesn't mean there isn't something going on, but lets try a simple restart first.

[techch01]

Hi @DCMattyG

I tried a restart and I have the same behavior !

Best regards,
Tariq ECHCHAITAM

[DCMattyG]

Hey @techch01, lets setup some time to look at this together. I can't seem to re-create this behavior, so it's difficult for me to figure out what's going on.

Would you mind reaching out to me at [email protected] so we can setup a 1:1 to figure out what's wrong?